CCA treated Douglas Fir marine plywood

Douglas Fir marine plywood

Meranti "Hydro-tek" marine plywood

Meranti "Aqua-tek" marine plywood

Sapele BS1088  marine plywood

Okoume BS1088  marine plywood

Mahogany "ribbon-stripe" marine plywood

Teak  marine plywood

Teak and Holly marine plywood 

Teak, Teak & Holly, Ribbon Mahogany
Standard Marine Plywood

Specifications:

Core Plywood Bonding type

The core veneer shall be bonded with type I exterior or similar glue.

Face Plywood Bonding type
The face veneer shall be bonded to the exterior grade composed core plywood with type I exterior or similar glue. Marine Plywood by Homestead does not warranty this product for exterior applications. However some success has been attained in exterior above water line applications when all sides and edges are sealed per above instructions.

Quality of  Core Veneers
Exterior grade composed core manufactured from selected untreated tropical hardwoods.  Core veneers shall be meranti, okoume or similar species.  Small splits are permitted, and there is no limitation on the number of pin knots or edge joints. Discoloration is permissible. Veneers need not be matched for color.

Quality of Face VeneersFace veneer shall be plain, rift or quarter sliced. The method of cutting is at the option of the manufacturer unless it is specified by the purchaser at the time of ordering. These shall present a solid surface, free from open defects. They shall be free from knots, other than sound pin knots, of which there shall be no more than 6 in any area 30cm square (1ft2), and not more than an average of 2 per 30cm square (1ft2) over the whole area of the board. The veneers shall be reasonably free from irregular grain, due note being taken to the characteristics of the species being used. Isolated pinholes not along the plane of the veneers, and occasional closed splits are permissible. Veneers showing compression failure shall be excluded. Occasional minor discoloration is permissible.

Core Veneer Thickness:
Tolerances of the core veneers vary as follows.
4mm +.02/-0.6 6mm +.04/-0.65 9mm +.06/-0.75 12mm +.09/-0.82
15mm +.1/-0.9 18mm +.12/-0.98 22mm +.16/-1.08 25mm +1.8/-1.16
From the above we can assume that 6mm material will arrive at thickness' between 6.04mm and 5.35mm.

Face Veneer thicknessStandard face veneer thickness shall be at least .6mm measured before sanding. A face veneer may also be applied to the back of the core plywood to balance the sheet but is not mandatory.

To generate an immediate quote including shipping please use our online shopping cart.

For direct ship orders:
-Use our online shopping cart to place your order
-Or if you prefer to call in your order use this number (419) 684-5275
-Or you can fax your order and credit card # to fax:(419) 684-9712
Do not email your credit card number

For direct ship quotes:
-To generate an immediate quote including shipping please use our online shopping cart.
-For quotes that you can't get on the shopping cart EMAIL US

 or call: 419-684-5275

For yard pick-up orders or immediate assistance:
Phone:(419) 684-5275
EMAIL US

Homestead Hardwoods
6910 CR 249
Vickery, Ohio 43464